1

After thoroughly cleaning the application area, use a grease pencil to mark the vertical and horizontal centers of the decal. If the letters have a transparent edge do not mark the area which will be covered by the decal.

2

Peel off transfer paper and spray the water/detergent solution (or a commercial preparation) onto the adhesicsve (back) side ot the decal.

3

Carefully position decal in position, there should be enough liquid so that it will slide over the surface.

4

Squeegee the decal down. Start gently from the center toward the outer edges and finish with firm pressure over the entire surface.

5

Peel off the transfer paper. Keep the free end close to the surface of the vehicle as you peel it back.

Hinge method for laminated products (clear edge)
Hinge method for larger decals with no laminate