1 |
 |
Thoroughly
clean the application area then use small pieces of tape and
your measuring device to position the decal. Use a grease
pencil or temporary marker to mark the centers. |
2 |
 |
Remove the decal
and check that the centers are aligned to the panel edges
(unless you intend it to be angled) |
3 |
 |
Use fresh tape along
the top edge of the decal to securely fasten it to the surface
in alignment with your marks |
4 |
 |
Lifting the decal
from the bottom edge, carefully pull off the backing paper
starting at a top corner. |
5 |
 |
Spray the water/detergent solution
(or a commercial preparation) to the adhesive (back)
side ot the decal. |
6 |
 |
Lay the decal flat
and squeegee it down. Start gently from the center toward
the outer edges and finish with firm pressure over the entire
surface. |
7 |
 |
Peel off first the
tape and then the transfer paper. Keep the free end close
to the surface of the vehicle as you peel it back. |
|
Login Status
