1

After thoroughly cleaning the application area, use a grease pencil to mark the vertical and horizontal centers of the decal.

2

Using small pieces of tape position the decal in alignment with the marks.

3

Tape securely along the top edge of the decal.

4

Lifting the decal from the bottom edge, carefully pull off the backing paper starting at the top edge.

5

Spray the water/detergent solution (or a commercial preparation) to the adhesive (back) side ot the decal.

6

Lay the decal flat and squeegee it down. Start gently from the center toward the outer edges and finish with firm pressure over the entire surface.

7

Peel off first the tape and then the transfer paper. Keep the free end close to the surface of the vehicle as you peel it back.

Hinge method for laminated decals (clear edge)
No-hinge method for smaller decals with no laminate